Hyundai Tucson Quiz
Body Work (Interior and Exterior)

Rear Seat Back Covering

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
29steps
~179min
5/5difficulty
1special tools
Done 0 of 29

Components and Component Location

COMPONENT LOCATION

1. Rear Seat Back Covering [L] 2. Rear Seat Back Covering [R]

Repair Procedures

REPLACEMENT

(LH)

  1. Remove the rear seat [G]. (Refer to Rear Seat - "Rear Seat")
  2. Press the stopper pin (B) and remove the rear seat headrest (A).
  3. Loosen the set screw, then remove the rear seat reclining lever (A).
  4. After loosening the mounting screw, remove the rear seat outer cover (A).
  5. Loosen the set screw, then remove the rear seat inner cover (A).
  6. Remove the elastic band (A) from the cushion frame.
  7. Remove the protector (A) from the front seat back frame.
  8. Using a screwdriver or removal tool, remove the child anchor cover (A).
  9. Using a screwdriver or removal tool, remove the rear seat back cover (A).
  10. Disconnect the rear seat heater connector (A).
  11. Remove the rear seat headrest guides (A) by pressing both sides of the lower part of the guides and pulling them out.
  12. After removing the hook-and-loop fastener (A) and clips (B) inside the rear seat cushion covering, remove the cushion covering (C).
  13. To install, perform the removal procedure in reverse order.

(RH)

  1. Remove the second row seat assembly [D]. (Refer to Rear Seat - "Rear Seat")
  2. Press the stopper pin (B) and remove the rear seat headrest (A).
  3. Loosen the set screw, then remove the rear seat reclining lever (A).
  4. After loosening the mounting screw, remove the rear seat outer cover (A).
  5. Using a screwdriver or removal tool, remove the child anchor cover (A).
  6. Using a screwdriver or removal tool, remove the cover from the rear seat suspension (A).
  7. Remove the elastic band (A) from the cushion frame.
  8. Remove the protector (A) from the front seat back frame.
  9. Using a screwdriver or removal tool, remove the rear seat back cover (A).
  10. Disconnect the rear seat heater connector (A).
  11. Using a screwdriver or removal tool, remove the armrest pad (B).
  12. Using a screwdriver or removal tool, remove the armrest from the rear seat back (B).
  13. Remove the rear seat armrest plate (A).
  14. Remove the rear seat headrest guides (A) by pressing both sides of the lower part of the guides and pulling them out.
  15. After removing the hook-and-loop fastener (A) and clips (B) inside the rear seat cushion covering, remove the cushion covering (C).
  16. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.