Hyundai Tucson LM Quiz
Restraints

Seat Belt Buckle Switch (BS) Repair Procedures

In this manual: Restraints
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
9steps
~54min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the front seat assembly. (Refer to Body - Front Seat group)
  3. Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch.

Installation
Make sure the harness wires are routed so that they are not pinched and do not interfere with other components.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least three minutes before starting work.
  3. Install the seat belt buckle switch.

    Tightening torque: 39.2 ~ 54 N·m

  4. Install the front seat assembly. (Refer to Body - Front Seat group)
  5. Connect the negative battery cable.
  6. After installing the seat belt buckle switch, check that the system operates correctly:
    A. Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.