Amplifier Input Voltage Inspection

NOTE

Be sure the battery is fully charged.

• Turn the ignition switch to OFF.
• Remove the upper fairing (see Upper Fairing Removal in the Frame chapter).

Do not disconnect the connectors.

• Connect a digital meter to the amplifier connector [A] with needle adapter set.

Special Tool - Needle Adapter Set: 57001-1457

Amplifier Input Voltage Connections to Amplifier Connector: Digital Meter (+) → BR/W lead Digital Meter (–) → BK/Y lead

• Turn the ignition switch to OFF.

If the reading is out of the standard, check the wiring (see Immobilizer System Circuit).

If the reading is within the standard, check the wiring to ECU (see Immobilizer System Circuit)

If the wiring is good, replace the amplifier (see Immobilizer System Parts Replacement in the Electrical System chapter).

• This code appears in the following conditions.

The transponder [A] in the ignition key is malfunction.

When the spare key of unregistration is used.

When the ignition key is registered in the registered ECU.

• Therefore, the service code 36 will disappear when the above issue is solved.