Engine Mount Repair Procedures

Removal and Installation

1. 1
   Disconnect the negative battery cable.
2. 2
   Remove the engine compartment cover. (Refer to Engine and Transaxle Assembly - "Under Hood")
3. 3
   Place a jack against the edge of the upper oil pan to support the engine.

   

   Insert the rubber block between the jack and the upper oil pan.

4. 4
   Remove the engine mount support bracket (A).

   Tightening torque: 88.3 ~ 108 N·m

5. 5
   Remove the engine mounting bracket (B).

   Tightening Torque: 58.8 ~ 74 N·m

   

6. 6
   Install in the reverse order of removal.
7. 7
   Remove the engine cover. (Refer to Engine and Transaxle Assembly - Engine Room Cover)
8. 8
   Remove the roll rod bracket (A). Tightening torque Bolt (B): 107.9 ~ 128 N·m Bolts (C): 49.0 ~ 64 N·m

   

9. 9
   Install in the reverse order of removal.
10. 10
    Remove the air cleaner assembly. (Refer to Air Intake and Exhaust System - "Air Cleaner").
11. 11
    Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
12. 12
    Remove the Engine Control Module (ECM). (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
13. 13
    Remove the engine cover. (Refer to Engine and Transaxle Assembly - Engine Room Cover)
14. 14
    Install the jack to the edge of the transaxle.
15. 15
    Remove the transaxle mounting bracket.

    1. Remove the service cover (A).

       

    2. Remove the transmission mounting bolts (A).

       Tightening torque: 107.9 - 128 N·m

    3. Remove the transmission mounting bracket (B).

       Tightening torque: 49.0 ~ 64 N·m

    

16. 16
    Install in the reverse order of removal.