Kia Cadenza VG Owner's Manual Quiz
Brake System

Repair Procedures of Front Wheel Speed Sensor

In this manual: Brake System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
8steps
~48min
2/5difficulty
04080120160200107.980N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Removal

  1. Remove the front wheel and tire.

    Tightening torque: 88.3 ~ 108 N·m

  2. Remove the front wheel speed sensor mounting bolt (A).

    Tightening torque: 6.9 ~ 9.8 N·m

  3. Remove the front wheel guard.
  4. Remove the front wheel speed sensor cable mounting bolt.
  5. Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.
  6. Installation is the reverse of removal.

Inspection

  1. Measure the output voltage between the wheel speed sensor terminal and the body ground.
    To protect the wheel speed sensor, use a 100 Ω resistor when measuring the output voltage, as shown in the illustration.
  2. Compare the wheel speed sensor output voltage change with the normal output voltage change as shown below.
    V_low: 0.59 V ~ 0.84 V V_high: 1.18 V ~ 1.68 V Frequency range: 1 ~ 2500 Hz

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.