Clutch Actuator Assembly Repair procedures
Removal
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Disconect the clutch actuator connector (A) and then remove the fork cover (B).
Tightening torque : 3.9 - 5,9 N·m

Install the special service tool (09430-G2100).
Loosen the bolts (A, B , C).
Tightening torque :
(A, C) 42.2 - 54 N·m
(B) 9.8 - 11,8 N·m

Fix the clutch fork by rotating a bolt (A) after installing special service tool (09430-G2100).

Remove the clutch actuator assembly (A) after loosening the bolts.
Tightening torque : 19.6 - 26 N·m

Inspection
Remove the clutch actuator.
(Refer to Dual Clutch Transmission Control System - "Clutch Actuator Assembly")
Install the clutch actuator (A) on special service tool (09430-F0100) and fix the actuator using nuts.

Remove clutch actuator motor (A).

Insert the special service tool (09430-F0100) into ball screw and rotate counter-clockwise until "clicking" sound is heard.

Measure the length (C) from reference plane (A) to the end of rod (B).
New part length : 64 mm (2.5197 in.)

Installation
Install in the reverse order of removal.
Adjustment
How to rewind clutch wear compensation
Install the faulty clutch actuator (A) on special service tool (09430-F0100) and fix the actuator using nuts.

Remove clutch actuator motor (A).

Insert the special service tool (09430-F0100) into ball screw and rotate counter-clockwise until "clicking" sound is heard.

Measure the each length (C) from reference plane (A) to the end of rod (B).

Pull the lever (A) until "click" sound is heard and then measure the each length (B) to check for pull rod length of faulty clutch actuator.


Install the new clutch actuator (A) on special tool (09430-F0100) and fix the actuator using nuts.

Remove clutch actuator motor (A).

Insert the special service tool (09430-F0100) into ball screw and rotate counter-clockwise until "clicking" sound is heard.

Remove sealing rubber (A).

After inserting the clutch actuator adjusting tool (09430-C1300) into the service hole, rotate it clockwise and rewind the new clutch actuator pull rod to the length measured in step 4.

After pulling the lever (A) until "click" sound is heard, measure the length (B) and check that it is the same as the length measured in step 5.


Install the sealing rubber (A).

Install the clutch actuator motor (A).
Tightening torque : 3.9 - 5,9 N·m

How to initialize clutch wear compensation
Install the clutch actuator (A) on special service tool (09430-F0100) and fix the actuator using nuts.

Remove clutch actuator motor (A).

Insert the special service tool (09430-F0100) into ball screw and rotate counter-clockwise until "clicking" sound is heard.

Tighten the nut (A) after setting the T plates (B) to 64 mm (2.5197 in).
Remove the sealing rubber (C).

Insert special service tool (09430-C1300) to the sealing rubber hole and then move to the T plates (A) by rotating counter-clockwise.

Fix the pull rod to hook (B) and install the sealing rubber (A).

Pull the lever (A) until "clicking" sound is heard and then measure the each length (B) again to check for specified length.
New part length : 82.5 mm (3.2480 in.)


Install the clutch actuator motor (A).
Tightening torque : 3.9 - 5,9 N·m
