DCT(Dual Clutch Transmission) System

Shift Lever Repair procedures

6steps
~36min
2/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Removal

  1. Shift the gear to "N".

  2. Remove the knob (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.

  3. Remove the floor console assembly.

    (Refer to Body - "Floor Console")

  4. Disconnect the main connector (A).

  5. Remove the shift cable.

    1. Remove the shift cable from the shift lever pim after removing the snap pin (A).

    2. Remove the cable socket (B) from the shift lever.

  6. Remove the shift lever assembly (B) by loosening bolts and then remove the wiring mounting clips (A).

    Tightening torque: 8.8 - 13,7 N·m

Installation

  1. Install in the reverse order of removal.