DCT(Dual Clutch Transmission) System

Gear Actuator Assembly Repair procedures

12steps
~72min
4/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Shut off the high voltage circuit.

    (Refer to Automatic Transaxle System - "High Voltage Shut-off Procedure")

  2. Drain the coolant of hybrid cooling system.

    (Refer to Hybrid Motor System - "Coolant")

  3. Remove the hybrid power control unit (HPCU) assembly.

    (Refer to Hybrid Control System - "Hybrid Power Control Unit")

  4. Disconnect the TCM connector (A) and ECM connector (B).

  5. Remove the TCM (A) and ECM (B).

    Tightening torque : 9.8 - 11,8 N·m

  6. Remove the HPCU tray (C) after removing the nut (A) and wiring mounting clips (B).

    Tightening torque :

    (A) 10.8 - 13,7 N·m

    (C) 21.6 - 24 N·m

  7. Disconnect the gear actuator motor connector (A) and gear actuator solenoid connector (B).

  8. Remove the gear actuator assembly after loosening bolts (A, B).

    Tightening torque :

    (A) 19.6 - 26 N·m

    (B) 9.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.