Clutch System

Concentric Slave Cylinder Assembly Repair procedures

6steps
~36min
2/5difficulty
Done 0 of 6

Removal

  1. Remove the hybrid motor assembly.

    (Refer to Hybrid Motor System - "Hybrid Motor Assembly")

  2. Remove the engine clutch actuator.

    (Engine Clutch System - "Engine Clutch Actuator")

  3. Remove the adapter (A).

  4. Loosen the bracket bolt (A) and concentric slave cylinder bolts (B) and then remove the concentric slave cylinder.

    Tightening torque :

    (A) 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

    (B) 9.8 - 19.6 N.m (1.0 - 1.2 kgf.m, 7.2 - 14.5 lb-ft)

Installation

  1. Install in the reverse order of removal.

  2. After replacing the concentric slave cylinder assembly, operate the followings in order using GDS / KDS equipment.

    1. Engine clutch inspection line learning and diagnostic information.

    2. Removal of air from engine clutch hydraulic pressure line

    3. Engine clutch/motor resolver adaptation.

    4. Stabilization of the engine clutch hardware transfer torque.