Clutch System

Engine Clutch Actuator Repair procedures

6steps
~36min
2/5difficulty
Done 0 of 6

Removal

  1. Turn the ignition switch OFF and disconnect the battery (-) terminal.

  2. Remove the under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  3. Disconnect the engine clutch actuator connector (A) and hose (B).

  4. Loosen the engine clutch actuator bolts (A) and then remove the engine clutch actuator.

    Tightening torque : 21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

Installation

  1. Install in the reverse order of removal.

  2. After replacing the engine clutch actuator, operate the followings in order using GDS / KDS equipment.

    1. Engine clutch inspection line learning and diagnostic information.

    2. Removal of air from engine clutch hydraulic pressure line

    3. Engine clutch/motor resolver adaptation.

    4. Stabilization of the engine clutch hardware transfer torque.