Audio Remote Control Repair Procedures

Inspection

1. Check the audio remote control switch (A) for resistance between the connector terminals in each switch position. [Left Sound]

   

   [Left-No Sound]

   

   [Audio]

   Switch	Connector Terminal	Resistance (±5%)
   Volume Down	2-7	6.81 kΩ
   Volume Up	2-7	4.61 kΩ
   Mode	2-7	2.11 kΩ
   Seek	2-7	1.11 kΩ
   Seek down	2-7	430 ?

   
   [Bluetooth + Voice]

   Switch	Connector Terminal	Resistance (±5%)
   Bluetooth OFF	2-5	12.1 kΩ
   Bluetooth ON	2-5	34.1 kΩ
   Voice	2-5	3.9 kΩ

   
   [Mute + Off + Reset]

   Switch	Connector Terminal	Resistance (±5%)
   Mute	3-4	0 ?
   Travel (General Type)	2-5	2.55 kΩ
   Reset (General Type)	2-5	5.55 kΩ
   Travel (Cruise Type)	2-5	1.1 kΩ
   Reset (Cruise Type)	2-5	4.1 kΩ

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the driver airbag module. (Refer to Group RT)
3. 3
   Remove the steering wheel. (Refer to Group ST - "Steering Column and Shaft")
4. 4
   Remove the steering wheel cover (A) after loosening the screws.

   

5. 5
   Disconnect the steering wheel remote control switch connector (A) after loosening the mounting screws.

   

   [Left Sound]

   

   [Left-No Sound]

   

   

Installation

1. 1
   Assemble the steering wheel remote control switch after connecting the connector.
2. 2
   Install the steering wheel.
3. 3
   Install the driver airbag module.

   Make sure the audio remote control switch and airbag module connectors are connected correctly.