Kia Soul EV Owner's Manual Quiz
Body (Interior and Exterior)

Glove Box Housing Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Maintenance — 17Drive Shaft and Axle — 15Suspension System — 36Steering — 24Restraints — 48Brake System — 37Body (Interior and Exterior) — 207Body Electrical System — 203Heating, Ventilation, and Air Conditioning — 80Electric Vehicle Battery System — 115
6steps
~36min
2/5difficulty
Done 0 of 6

Replacement
  • Wear gloves to protect your hands.
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Using a flat-tip screwdriver or trim removal tool, remove the crash pad side cover [RH] (A).
  2. Loosen the glove box housing mounting bolts (A).
  3. Loosen the mounting screws, then remove the crash pad lower panel (A) using a screwdriver.
  4. Disconnect the glove box lamp connector (A).
  5. Remove the glove box housing mounting clip (A).
    • When installing the glove box housing, be sure to insert the locking pin (A) into the wire harness band (B).
  6. Install in the reverse order of removal.
    • Make sure the connectors are connected correctly.
    • Replace all damaged clips.

Test yourself

A quick Kia Soul EV Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.