Kia Soul EV Owner's Manual Quiz
Drive Shaft and Axle

Rear Hub - Carrier Repair Procedures

In this manual: Drive Shaft and Axle
General Information — 17Maintenance — 17Drive Shaft and Axle — 15Suspension System — 36Steering — 24Restraints — 48Brake System — 37Body (Interior and Exterior) — 207Body Electrical System — 203Heating, Ventilation, and Air Conditioning — 80Electric Vehicle Battery System — 115
16steps
~101min
4/5difficulty
1special tools
04080120160200107.980N·mlb·ft
Tightening torque found on this page
Done 0 of 16

Replacement

  1. Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
  2. Remove the rear wheel and tire (A) from the rear hub.

    Tightening torque: 88.3 ~ 108 N·m

  3. Loosen the guide pin bolt (B) and remove the rear caliper body (A).

    Tightening torque: 21.6 ~ 31 N·m

  4. Remove the pads (B) from the caliper carrier (A).
  5. Remove the brake caliper mounting bolts (B) and secure the brake caliper assembly (A) with wire.

    Tightening torque: 63.7 ~ 74 N·m

  6. Disconnect the rear wheel speed sensor connector (A).
  7. Loosen the screws (B) and remove the brake disc (A).

    Tightening torque: 4.9 - 5.8 N·m

  8. Loosen the bolts and remove the hub bearing (A).

    Tightening torque: 49.0 ~ 59 N·m

  9. Remove the hub bearing using a rubber mallet.
  10. Install in the reverse order of removal.

Inspection

  1. Check the hub for cracks and worn splines.
  2. Check the brake disc for scratches and damage.
  3. Check the rear axle beam for cracks.
  4. Check the bearing for cracks or damage.

Installation

  1. Install in the reverse order of removal.
    Use SST (09581-11000) when installing the brake caliper assembly. (Refer to Brake System - "Front Disc Brake")
  2. Check the front alignment. (Refer to Suspension System - "Front Wheel Alignment")

Test yourself

A quick Kia Soul EV Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.