Kia Soul EV Owner's Manual Quiz
Body (Interior and Exterior)

Rear Seat Cushion Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Maintenance — 17Drive Shaft and Axle — 15Suspension System — 36Steering — 24Restraints — 48Brake System — 37Body (Interior and Exterior) — 207Body Electrical System — 203Heating, Ventilation, and Air Conditioning — 80Electric Vehicle Battery System — 115
5steps
~35min
3/5difficulty
1special tools
Done 0 of 5

Replacement
  • Wear gloves to protect your hands.
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Loosen the heater ECU mounting screws (A).
  3. Disconnect the heater ECU connector (B) and remove the mounting clips (C). [LH]
    [RH]
  4. Remove the ring clip (A) and the hook-and-loop fastener (C) on the rear of the seat cushion, then remove the rear seat cushion cover (B). [Rear side]
    [Front side]
  5. Install in the reverse order of removal.
    • To prevent wrinkles, make sure the material is evenly stretched over the cover (B) before fastening the clips (A).
    • Replace the ring clips with new ones using the special service tool (C) (09880-4F000).

Test yourself

A quick Kia Soul EV Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.