Kia Soul EV Owner's Manual Quiz
Body (Interior and Exterior)

Rear Seat Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Maintenance — 17Drive Shaft and Axle — 15Suspension System — 36Steering — 24Restraints — 48Brake System — 37Body (Interior and Exterior) — 207Body Electrical System — 203Heating, Ventilation, and Air Conditioning — 80Electric Vehicle Battery System — 115
12steps
~72min
3/5difficulty
0102030405025.519N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Replacement

[Rear Seat Back Assembly]
  1. Disconnect the rear seat belt lower anchor (C) by pressing the stopper pin (B) of the center mini buckle (A) with a flat-tip screwdriver.
  2. Fold the rear seat back assembly forward.
  3. Remove the center hinge cover (A).
  4. Loosen the rear seat back mounting bolt (A).

    Tightening torque: 16.7 ~ 26 N·m

  5. Remove the rear seat back assembly (A).
  6. Install in the reverse order of removal.
  7. Remove the luggage compartment trim.
    1. Remove the luggage compartment panel (A).
    2. Remove the luggage box (A).
  8. Remove the rear seat back [LH]. (Refer to Rear Seat - Rear Seat Assembly)
  9. Loosen the rear seat cushion mounting bolt (A).

    Tightening torque: 16.7 ~ 26 N·m

  10. Remove the rear seat cushion assembly (A) by pulling it upward.
  11. Disconnect the seat cushion heater connector (A). [LH]
    [RH]
  12. Install in the reverse order of removal.
[Rear Seat Cushion Assembly]

Test yourself

A quick Kia Soul EV Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.