Electronic Parking Brake (EPB) Repair Procedures

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Remove the floor console assembly. (Refer to Body - "Floor Console Assembly")
3. 3
   Disconnect the connector (A) from the EPB control unit.

   

4. 4
   Remove the nuts securing the EPB control unit (B), then remove the EPB control unit.

   Torque: 19.6 ~ 29 N·m

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   After replacing the EPB control unit with a new one, perform the "Variant Coding" procedure. (Refer to "Variant Coding")
3. 3
   Perform "G-Sensor Calibration" using GDS.
4. 4
   After installing the EPB module, check that the brake operates normally by pressing the EPB switch more than 3 times.

Variant Coding

1. 1
   Ignition OFF, connect GDS.
2. 2
   Ignition "ON" and engine "OFF" select the vehicle name and the EPB system.
3. 3
   Select the EPB Variant coding mode.

   

4. 4
   Perform the "EPB Variant Coding" procedure using GDS.

   

5. 5
   Perform the "Variant Coding" procedure.