Drive Shaft and Axle

Dynamic Damper

13steps
~83min
4/5difficulty
1special tools
Done 0 of 13

Components and Component Location

Components

[RH]

1. BJ assembly
2. Clip
3. BJ boot band
4. Boot
5. Dynamic Damper Band
6. Dynamic Damper
7. Shaft
8. TJ Boot Band
9. TJ Boot
10. Spider Assembly
11. Snap Ring
12. TJ Housing
13. Snap ring

[LH]

1. BJ Assembly
2. BJ Snap Ring
3. BJ Boot Band
4. BJ Boot
5. Shaft
6. TJ Boot Band
7. TJ Boot
8. Spider Assembly
9. Snap Ring
10. TJ Housing
11. Snap Ring

Repair Procedures

Replacement

  1. Remove the front drive shaft. (Refer to Drive Shaft and Axle - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft and Axle - "TJ Joint")
  3. Remove both dynamic damper bands (B) from the dynamic damper (A).
  4. Secure the drive shaft (A) in a vise (B), as shown in the illustration.
  5. Apply soapy powder on the shaft to prevent damage between the shaft splines and the dynamic damper when the dynamic damper is removed.
  6. Carefully separate the dynamic damper (A) from the shaft (B).

Installation

  1. Apply soap powder to the shaft to prevent damage between the shaft splines and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper band (A).
  4. Using SST (09495-3K000), secure the TJ boot bands (B).

    Clearance (A): 2.0 mm (0.0787 in.) or less

  5. Install the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  6. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  7. Check the front wheel alignment. (Refer to Suspension System - Alignment)

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.