Using the Tire Mobility Kit

1. Remove the speed limit label (1) from the sealant bottle (2) and place it in a visible location inside the vehicle, such as on the steering wheel, to remind the driver not to drive too fast.

2. Injecting sealant: Strictly follow the specified sequence, otherwise the sealant may leak out under high pressure.

3. Shake the sealant bottle.

4. Screw the connecting hose (10) onto the sealant bottle connector.

5. Make sure the cap (9) is closed.

6. Unscrew the valve cap from the deflated tire valve, then connect the filler hose (3) of the sealant bottle to the valve.

7. Insert the sealant bottle into the compressor housing (5) so that the bottle stands upright.

8. Make sure the compressor switch is in the OFF (0) position.

9. Connect the compressor to the vehicle power outlet using the cable and plugs.

NOTICE

Use only the front passenger side power outlet.

10. With the ignition or engine on, set the start/stop button to ON and run the compressor for approximately 3 minutes to inject the sealant. The tire pressure after filling does not matter and will be checked/adjusted later.

11. Turn off the compressor.

12. Disconnect the hose from the sealant bottle connector and from the tire valve.

Return the Tire Mobility Kit to its storage location in the vehicle.

WARNING

Carbon monoxide poisoning and suffocation may occur if the engine is left running in a poorly ventilated or enclosed area (for example, inside a garage).