Child Restraint System (CRS) Installation

WARNING

Before installing a child restraint system, always:

Read and follow the instructions provided by the child restraint system manufacturer.

Failure to observe all warnings and instructions may increase the risk of SERIOUS INJURY or DEATH in the event of a collision.

WARNING

If the vehicle headrest interferes with the proper installation of the child restraint system, the headrest of the corresponding seat must be adjusted or completely removed.

After selecting a suitable child restraint system for your child and checking that it is correctly installed on the seat, there are three general steps for proper installation:

• Properly secure the child restraint system to the vehicle. All child restraint systems must be secured to the vehicle with the lap belt or the lap portion of the lap/shoulder belt, with the ISOFIX upper tether and/or ISOFIX anchorages and/or with the support leg.
• Make sure the child restraint system is securely installed. After installing the child restraint system in the vehicle, push and pull the seat forward and from side to side to make sure it is firmly attached to the seat. A child restraint system secured with the seat belt should be installed as tightly as possible. However, some side movement can be expected. When installing a child restraint system, adjust the vehicle seat and seatback (up and down, forward and backward) so that your child can sit comfortably in the child restraint system.
• Secure the child in the child restraint system. Make sure the child is properly secured in the child restraint system in accordance with the child restraint system manufacturer's instructions.

CAUTION

A child restraint system in a closed vehicle can become extremely hot. To prevent burns, check the seat surface and buckles before placing your child in the child restraint system.