Mazda 6 Quiz
Body

Power window main switch inspection

In this manual: Body
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Drivers side

1. Remove the driver-side front door trim.

2. Connect the power window main switch connector.

3. Measure the voltage at the power window main switch terminals as indicated below.

4. Disconnect the power window main switch connector before inspecting for continuity at terminals 1M (1J*2) and 1F (1L*2).

  • If not as specified, inspect the parts listed under Action.
  • If the parts and wiring harnesses are okay but the system still does not work properly, replace the power window main switch.
Terminal voltage list (Reference)


*1 : With rear power window system (L.H.D.)

*2 : Without rear power window system (L.H.D.)

*3 : R.H.D.

Except drivers side

1. Turn the power-cut switch to UNLOCK.

2. Inspect for continuity between the power window main switch terminals using an ohmmeter.

  • If not as specified, replace the power window main switch.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.