Transmission & Driveline

Front Final Drive Assembly

~1min read

Exploded View

Flame assembly Front final drive assembly Front cross member assembly
: vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.

Removal and Installation

REMOVAL

Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.

Drain gear oil. Refer to Draining.

Remove front stabilizer clamps. Refer to Removal and Installation.

Remove both front drive shafts. Refer to Removal and Installation.

Remove front cross member assembly .

Remove front propeller shaft from front final drive. Refer to Removal and Installation.

Remove air breather hose from front final drive. Refer to Removal and Installation.

Set a suitable jack to front final drive assembly.

Remove front final drive assembly mounting bolts and nuts ( ), then remove front final drive assembly.

INSTALLATION

Note the following, install in the reverse order of removal.

  • For each tightening torque, refer to Exploded View.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER INSTALLATION

Check the oil level and the oil leakage after installation. Refer to Inspection.