Transmission & Driveline
Side Oil Seal
In this manual: Transmission & Driveline
~1min read
Exploded View

| Side oil seal | Front final drive assembly | ||||
Removal and Installation
REMOVAL
Drain gear oil. Refer to Draining.
Remove both front drive shafts from front final drive assembly. Refer to Removal and Installation.
Remove side oil seal, using oil seal remover (A) (commercial service tool).

INSTALLATION
Using the drifts (A and B), drive side oil seal until it becomes flush with the gear carrier end.

| A | : Drift [SST: ST30720000 (NI-25405)] |
| B | : Drift [SST: ST27863000 ( — )] |
Install both front drive shafts. Refer to Removal and Installation.
Refill gear oil to the final drive. Refer to Refilling.
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER INSTALLATION
Check oil level and final drive for oil leakage. Refer to Inspection.
Was this page helpful?