Lower Link
Exploded View

| Frame | Eccentric disc | Adjusting bolt | |||
| Stopper rubber | Lower link | Steering knuckle | |||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, ft-lb) | |||||
Removal and Installation
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove brake hose bracket from steering knuckle. Refer to Removal and Installation.
Remove brake caliper assembly. Hang brake caliper assembly in a place where it will not interfere with work. Refer to FRONT BRAKE CALIPER ASSEMBLY : Removal & Installation.
Remove wheel sensor and harness connector. Refer to Removal and Installation.
Set suitable jack under lower link.
Remove steering knuckle.
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
Remove shock absorber mounting bolt (lower side), and separate shock absorber from lower link. Refer to Removal and Installation.
Remove stabilizer bar assembly. Refer to Removal and Installation.
Remove mounting bolts, eccentric discs, and adjusting bolts, and remove stopper rubber and lower link.
Perform inspection after removal. Refer to Inspection.
INSTALLATION
Note the following, and install in the reverse order of removal.
Perform final tighting of lower link (frame side) by the following procedures.
Measure between wheel center and fender arch (A).

Set the wheel chocks on the rear tires.
Jack up front of the vehicle and set the rigid rack.
Remove the front tires.
Set suitable jack (A) on the left and right steering knuckles
(lower link ball joint fastening part).
Jack up the left and right steering knuckles until the vehicle no longer floats off the rigid rack (A).

Measure between wheel center and fender arch (A).

Tight the mounting nuts of lower link (frame side) to the specified torque. Refer to Exploded View.
Perform inspection after installation. Refer to Inspection.
Perform adjustment after installation. Refer to Adjustment.
Inspection
INSPECTION AFTER REMOVAL
Appearance
Check the following items, and replace the part if necessary.
Lower link for deformation, cracks or damage.
Bushings for complete seperation. (If completely seperated, inner metal can be pulled out from lower link.)
Ball joint boot for cracks or other damage, and also for grease leakage.
Ball Joint Inspection
Manually move ball stud to confirm it moves smoothly with no binding.
Swing Torque Inspection
Move the ball joint at least ten times by hand to check for smooth movement.
Hook a spring balance (A) at cotter pin mounting hole. Confirm spring balance measurement value is within specifications when ball stud begins moving.

| Swing toque | : Refer to Ball Joint. |
If swing torque exceeds standard range, replace lower link assembly.
Rotating Torque Inspection
Move the ball joint at least ten times by hand to check for smooth movement.
Attach mounting nut to ball stud. Check that rotating torque is within specifications with a preload gauge [SST: ST3127S000 (NI-25765-A)] (A).

| Rotating toque | : Refer to Ball Joint. |
If rotating torque exceeds standard range, replace lower link assembly.
Axial End Play Inspection
Move the ball joint at least ten times by hand to check for smooth movement.
Move tip of ball stud in axial direction to check for looseness.
If there is axial end play, replace lower link assembly.
INSPECTION AFTER INSTALLATION
Check wheel sensor harness for proper connection. Refer to Exploded View.
Check wheel alignment. Refer to Inspection.
Adjustment
ADJUSTMENT AFTER INSTALLATION
Adjust neutral position of steering angle sensor. Refer to Work Procedure.