Body Exterior, Doors, Roof & Vehicle Security

Rear Door Glass

~5min read

Exploded View

Rear door glass run Rear door panel Hole seal 1
Hole seal 2 Rear door glass Rear door lower sash upper
Rear door lower sash lower Rear door inner frame rear Rear door inner frame front
Rear door regulator assembly Rear door power window motor Rear door regulator
: Clip
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
: Body grease
, , , , , , , : Indicates that the part is connected at points with same symbol in actual vehicle.

Rear Door Glass

Removal and Installation

REMOVAL

Remove rear door glass run. Refer to Removal and Installation.

Remove rear door lower sash upper and rear door lower sash lower. Refer to Removal and Installation.

Remove hole seal 1 from rear door panel.

Reconnect power window switch connector with rear door finisher.

Operate power window switch to raise or lower rear door glass until rear door glass mounting bolts can be seen, and then remove rear door glass mounting bolts.

Pull up rear door glass to upward, and then remove rear door glass.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Inspection and Adjustment

SYSTEM INITIALIZATION

Perform additional service for operating the power window control system normally after installing rear door glass. Refer to Work Procedure.

FITTING INSPECTION

  • Check that the glass is fitted securely into the sash groove.

  • Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each mounting bolt to correct the glass position if the clearance between the glass and sash are not parallel.

Rear Door Lower Sash

Removal and Installation

REMOVAL

Remove rear door glass run. Refer to Removal and Installation.

Remove rear door inner frame rear. Refer to Removal and Installation.

Fully close rear door glass.

Remove mounting bolt , and then remove rear door lower sash lower.

Fully open rear door glass.

Remove hole seal 1 and hole seal 2 from rear door panel.

Loosen upper side mounting bolt and remove lower side mounting bolt , and then remove rear door lower sash upper.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Rear Door Glass Run

Removal and Installation

REMOVAL

Remove rear door sash cover. Refer to Removal and Installation.

Remove rear door sash inner cover and inside seal. Refer to Removal and Installation.

Reconnect power window main switch connector with rear door finisher.

Fully open rear door glass.

Disengage rear door glass run from rear door panel according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove rear door glass run.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Rear Door Inner Frame

Removal and Installation

REMOVAL

Rear Door Inner Frame Front

Remove pull handle bracket. Refer to Removal and Installation.

Apply protective tapes (A) on the part to protect it from damage.

Disengage fixing clips by using removal tool (B), and then remove rear door inner frame front.

Rear Door Inner Frame Rear

Remove rear door finisher. Refer to Removal and Installation.

Disconnect rear door switch harness connector and disengage harness fixing clips.

: Clip

Apply protective tapes (A) on the part to protect it from damage.

Disengage rear door inner frame rear fixing clips by using removal tool (B).

Remove grommet of rear door inside handle cable and rear door lock knob cable , and then remove rear door inner frame rear.

INSTALLATION

Install in the reverse order of removal.