Body Exterior, Doors, Roof & Vehicle Security

Rear Door Regulator

~2min read

Exploded View

For exploded view of rear door regulator, refer to Exploded View.

Removal and Installation

REMOVAL

Remove rear door glass. Refer to Removal and Installation.

Disengage fixing portion using a remover tool (A) according to numerical order 1→2 as shown in the figure, and then disconnect rear door power window motor harness connector.

Remove mounting nut and bolts , and then remove rear door regulator assembly.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Disassembly and Assembly

DISASSEMBLY

Remove rear door regulator assembly. Refer to Removal and Installation.

Remove rear door power window motor mounting bolts, and then remove rear door power window motor.

ASSEMBLY

Note the following item, and then assemble in the reverse order of disassembly.

Inspection and Adjustment

SYSTEM INITIALIZATION

Perform additional service for operating the power window control system normally after installing rear door regulator assembly. Refer to Work Procedure.

FITTING INSPECTION

  • Check that the glass is fitted securely into the sash groove.

  • Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each mounting bolt to correct the glass position if the clearance between the glass and sash are not parallel.