Body Exterior, Doors, Roof & Vehicle Security

Side Window Glass

~3min read

Exploded View

Body side outer panel Side window glass Glass primer
Adhesive
Edge Adhesive mark
: Clip
: Always replace after every disassembly.

Unit: mm (in)

PortionPrimer rangeAdhesive range
LN
Side window glass - Body side outer panel - F

From edge, more than 20.0

(0.79)

7.0 + 2.0, - 0.0

(0.28 + 0.08. - 0.0)

12.0 + 2.0, - 0.0

(0.47 + 0.08, - 0.0)
- G

From edge, 8.0

(0.32)
H

More than 20.0

(0.79)
- I

From edge, more than 20.0

(0.79)
- J

From edge, 11.5

(0.45)
K

More than 30.0

(1.18)

Removal and Installation

REMOVAL

Remove rear side spoiler. Refer to Removal and Installation.

Remove luggage side upper finisher. Refer toRemoval and Installation .

Disconnect window antenna connectors .

Cut the adhesive using a piano wire.Apply protective tapes (A) on body side outer panel around side window glass to protect painted surface from damage.

Tie both ends of the piano wire (B) to wire grip (A), etc.
To cut adhesive using piano wire (A) alongside of side window glass and body side outer panel as shown in the figure.

Use suction lifter (A) to remove side window glass from the vehicle.

INSTALLATION

Use a cutter knife or scraper, and leave the adhesive on the body side thin and smooth as shown in the figure.

Clean the bonded area on side window glass and body side outer panel using a white gasoline or degreasing agent.

Apply glass primer along the entire circumference of side window glass. For the range of glass primer, refer to Exploded View.

Apply adhesive to side window glass by using an adhesive gun. For the volume of adhesive, refer to Exploded View.

B : More than 30 mm (1.18 in)

Install side window glass to body side outer panel.

Correct any adhesive overflow or shortage using a spatula to make the surface smooth.

Remove protective tapes.

Install removed parts.

Inspection

WATER LEAKAGE INSPECTION