Steering

Steering Column

~5min read

Exploded View

WITHOUT ELECTRIC MOTOR

Steering column assembly Upper joint
: N·m (kg-m, ft-lb)

WITH ELECTRIC MOTOR

Steering column assembly Upper joint
: N·m (kg-m, ft-lb)

Removal and Installation

REMOVAL

Set vehicle to the straight ahead position.

Place the tilt to the highest position. Place the telescopic to the middle position. (WITHOUT ELECTRIC MOTOR)

Place the tilt to the downest position. Place the telescopic to the longest position. (WITH ELECTRIC MOTOR)

Remove steering wheel. Refer to Removal and Installation.

Remove the cluster lid A. Refer to Removal and Installation.

Remove spiral cable. Refer to Removal and Installation.

Remove combination switch. Refer to Removal and Installation.

Remove driver knee air bag module. Refer to Removal and Installation.

Remove switch harness clips to braket (WITHOUT ELECTRIC MOTOR).

Disconnect each harness connectors installed to steering column assembly. (WITH ELECTRIC MOTOR).

Remove the upper joint fixing bolt and nut (steering shaft side).

Separete the collar and steering shaft from upper joint .

Remove the mounting bolts , and remove steering column assembly .

If necessary, remove upper joint and bolt from steering column assembly .

Perform inspection after removal. Refer to Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • When installing the steering column assembly, perform the following procedure.

    1. Insert bolt through the steering column hole.

    2. Temporary tighten the bolt with hand.

    3. Insert bolts through the steering column hole.

    4. Temporary tighten the bolt with hand.

    5. Tighten bolt to the specified torque.

    6. Tighten bolts to the specified torque.

  • Be careful of the following points when installing the steering column assembly.

  • To install the upper joint , align it with the matching marks on the steering column assembly put during the removal.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER REMOVAL

Check the following items and replace, if necessary.

  • Check each part of steering column assembly for damage or other malfunctions. Replace if there are any abnormal conditions.

  • Measure steering column rotating torque using a preload gauge (commercial service tool) (A). Replace steering column assembly if the rotating torque is outside the standard.

    Rotating torque : Refer to Steering Column.
  • With the column telescopic set to the longest position, measure the length (A) shown in the figure, if vehicle has been involved in a minor collision. Replace steering column assembly if out side the standard.

    Steering column length [maximum telescopic (A)] : Refer to Steering Column.

INSPECTION AFTER INSTALLATION

Check the following items and replace, if necessary.

  • Check each part of steering column assembly for damage or other malfunctions. Replace if there are any abnormal conditions.

  • Check tilt and telescopic mechanism operating range tilt operating range (A), telescopic operating range (B) as shown in the figure.

    Tilt operating range (A) : Refer to Steering Column.
    Telescopic operating range (B) : Refer to Steering Column.
  • After installation, turn steering wheel to make sure it moves smoothly while turning to the left and right stops.

  • Make sure that the steering wheel is in a neutral position when driving straight ahead.

  • Rotate steering wheel to check for decentered condition, binding, noise, or excessive steering effort.

  • Check the steering wheel play, neutral position steering wheel, steering wheel turning torque, and front wheel turning angle.

    • Steering wheel play: Refer to Inspection.

    • Neutral position steering wheel, steering wheel turning torque, and front wheel turning angle: Refer to Inspection.

  • Perform rack end value reset. Refer to Work Procedure.

  • Adjust neutral position of steering angle sensor. Refer to Work Procedure.

  • If equipped with ProPILOT Assist, perform steering torque calibration after replacing or removal and installation the steering wheel. Refer to Work Procedure.