Transfer Control Actuator
Exploded View

| Transfer assembly | Transfer control actuator | bracket | |||
| : N·m (kg-m, in-lb) |
Removal and Installation
REMOVAL
The ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector
.

Remove harness clip
.

Remove transfer control actuator mounting bolt (
) and remove bracket
.

Remove transfer control actuator
.

INSTALLATION
Note the following, and install in the reverse order of removal.
Never damage oil seal of transfer control actuator.
Never contaminate or damage the oil seal mounting surface.
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER REMOVAL
Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.
Check the transfer assembly as follows.Install the suitable tool (A) to transfer assembly as shown in the figure.

INSPECTION AFTER INSTALLATION
After driving, check the surface fitting transfer control actuator to transfer assembly for fluid leakage.
ADJUSTMENT AFTER INSTALLATION
When replacing transfer control actuator, performe writing unit parameter. Refer to Description.