Transmission & Driveline
Unit Parameter Writing
In this manual: Transmission & Driveline
3steps
~18min
2/5difficulty
Done 0 of 3
Description
After working the following, transfer unit parameter must be written to transfer control unit.
Transfer control unit replacing
Transfer assembly replacing
Transfer control actuator replacing
Transfer range position sensor replacing
Transfer cam position sensor replacing
Transfer case component parts disassembling
For the work procedure, refer to Work Procedure.
Work Procedure
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.

| : Side surface | |
| : Top surface |
GO TO 2.
WRITING UNIT PARAMETER
With CONSULT
Ignition switch ON.
Select “Work support” in “AWD/4WD”.
Perform “Unit parameter writing” to the CONSULT display.
WORK END
Was this page helpful?