4WD mode indicator lamp (4WD-V)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK 1. Turn the ignition switch ON. 2. Change 4WD mode switch to “4WD-V”.3. Check that 4WD mode indicator lamp (4WD-V) turns on.
Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to diagnosis procedure. Refer to DLN-81, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK 4WD WARNING LAMPStart the engine and drive at 30 km/h or more for approximately 1 minute.
Does 4WD warning lamp turn ON? YES >> Proceed to DLN-80, "Diagnosis Procedure".
NO >> GO TO 2.
2.CHECK 4WD MODE SWITCHPerform the trouble diagnosis for 4WD mode switch. Refer to DLN-44, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the error-detected parts.
3.CHECK 4WD MODE INDICATOR LAMP SIGNAL
With CONSULT-III
1. Start the engine.
CAUTION:Stop the vehicle. 2. Change 4WD mode switch to “4WD-V” from “2WD”.
3. Check “INDICATOR” of CONSULT-III “DATA MONITOR” for “ALL MODE AWD/4WD”.
Does the item on “DATA MONITOR” indicate “4WD-V”? YES >> GO TO 4.
NO >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
4.CHECK COMBINATION METER POWER SUPPLY CIRCUITPerform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace the error-detected parts.