P181F incomplete calibration
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Turn the ignition switch OFF to ON.
2. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is DTC “P181F” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-51, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM WRITING UNIT PARAMETER 1. Erase self-diagnostic result for “ALL MODE AWD/4WD”. 2. Perform writing unit parameter. Refer to DLN-39, "Work Procedure".3. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is any DTC except “P181F” detected? YES >> Check DTC.
NO >> GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Erase self-diagnostic result for “ALL MODE AWD/4WD”. 2. Turn the ignition switch OFF, and then wait 10 seconds or more.
3. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is DTC “P181F” detected? YES >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
NO >> Check 4WD control module pin terminals for damage or loose connection with harness connector.
If any items are damaged, repair or replace the error-detected parts.