P182F coupling temperature sensor left
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Turn the ignition switch OFF to ON.
2. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is DTC “P182F” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-60, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK ELECTRIC CONTROLLED COUPLING (LH) TEMPERATURE SENSOR POWER SUPPLY 1. Turn the ignition switch OFF. 2. Disconnect transfer fluid temperature sensor harness connector.3. Turn the ignition switch ON.
CAUTION:Never start the engine.
4. Check the voltage between rear final drive assembly harness connector terminals.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK ELECTRIC CONTROLLED COUPLING (LH) TEMPERATURE SENSOR CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect 4WD control module harness connector.3. Check the continuity between 4WD control module harness connector and rear final drive assembly harness connector.

4. Check the continuity between transfer fluid temperature sensor harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace error-detected parts.
3.CHECK ELECTRIC CONTROLLED COUPLING (LH) TEMPERATURE SENSORCheck the electric controlled coupling (LH) temperature sensor. Refer to DLN-61, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Electric controlled coupling (LH) temperature sensor is malfunctioning. Replace electric controlled coupling (LH). Refer to DLN-139, "Removal and Installation".
4.CHECK TERMINALS AND HARNESS CONNECTORSCheck the pin terminals for damage or loose connection with each harness connector.
Is the inspection result normal? YES >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
NO >> Repair or replace error-detected parts.
Component Inspect
1.CHECK ELECTRIC CONTROLLED COUPLING (LH) TEMPERATURE SENSOR 1. Turn the ignition switch OFF. 2. Disconnect rear final drive assembly harness connector.3. Check the resistance between transfer control fluid temperature sensor connector terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Electric controlled coupling (LH) temperature sensor is malfunctioning. Replace electric controlled coupling (LH). Refer to DLN-139, "Removal and Installation".