A/C auto AMP. Connection recognition signal circuit
In this manual: Meter, Warning Lamp & Indicator
~1min read
Diagnosis Procedure1.CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL 1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.
Is the inspection result normal? YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect combination meter connector and A/C auto amp. connector.
3. Check continuity between combination meter harness connector and A/C auto amp. harness connector.
*1: 4WD models *2: 2WD models
4. Check continuity between combination meter harness connector and ground.
Is the inspection result normal? YES >> INSPECTION END