Meter, Warning Lamp & Indicator
Oil pressure switch signal circuit
In this manual: Meter, Warning Lamp & Indicator
~1min read
Component Function Check
1.CHECK COMBINATION METER INPUT SIGNALSelect the “Data Monitor” for the “METER/M&A” and check the “OIL W/L” monitor value.
“OIL W/L”
Ignition switch ON : On
Engine running : Off
>> INSPECTION END
Diagnosis Procedure
1.CHECK OIL PRESSURE SWITCH CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R connector and oil pressure switch connector.3. Check continuity between IPDM E/R harness connector and oil pressure switch harness connector.

4. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> INSPECTION END
NO >> Repair harness or connector.
Component Inspection
1.CHECK OIL PRESSURE SWITCHCheck continuity between oil pressure switch and ground.


Is the inspection result normal? YES >> INSPECTION END
NO >> Replace oil pressure switch. Refer to LU-8, "Inspection" (MR16DDT), LU-25, "Inspection" (HR16DE), or LU-33, "Inspection" (K9K).
Was this page helpful?