Seat belt buckle switch signal circuit (passenger side)
Diagnosis Procedure
1.CHECK SEAT BELT BUCKLE SWITCH (PASSENGER SIDE) CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect combination meter connector and seat belt buckle switch (passenger side) connector.3. Check continuity between combination meter harness connector and seat belt buckle switch (passenger side) harness connector.

*1: RHD models
*2: LHD models
4. Check harness continuity between combination meter harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> Repair harness or connector.
2.CHECK SEAT BELT BUCKLE SWITCH (PASSENGER SIDE) GROUND CIRCUITCheck harness continuity between seat belt buckle switch (passenger side) harness connector and ground.

*1: RHD models
*2: LHD models
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair harness or connector.
Component Inspection (Seat Belt Buckle Switch)
1.CHECK SEAT BELT BUCKLE SWITCH (PASSENGER SIDE) 1. Turn ignition switch OFF. 2. Disconnect the seat belt buckle switch (passenger side) connectors.3. Check continuity between terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace the seat belt buckle (passenger side). Refer to SB-8, "SEAT BELT BUCKLE : Removal and Installation".
Component Inspection (Occupant Detection Unit)
1.CHECK OCCUPANT DETECTION UNIT 1. Turn ignition switch OFF. 2. Disconnect the occupant detection unit connector.3. Check continuity between terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace the seat cushion trim and pad. Refer to SE-21, "SEAT CUSHION : Disassembly and Assembly" (2WD) or SE-29, "SEAT CUSHION : Disassembly and Assembly" (4WD).