Door & Lock Type 1
Anti-hijack function does not operate
In this manual: Door & Lock Type 1
~1min read
Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode.
3. Check “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” Refer to DLK-41, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (With Super Lock)".
Is the inspection result normal? YES >> GO TO 2 NO >> Set “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT”.
2.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Was this page helpful?