Door & Lock Type 1
Auto door lock operation does not operate
In this manual: Door & Lock Type 1
~1min read
Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING IN “WORK SUPPORT
”
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.3. Check “AUTO LOCK SET” in “WORK SUPPORT”.
Refer to DLK-43, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Super Lock)".
Is the inspection result normal? YES >> GO TO 2.
NO >> Set “AUTO LOCK SET” setting in “WORK SUPPORT”.
2.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Was this page helpful?