B1024 pass A/B deact SW
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On Board Diagnosis Function".
NOTE:
SRS does not enter diagnosis mode if no malfunction is detected in user mode.
Is malfunctioning part detected? YES >> Refer to SRC-34, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
(To discharge backup capacitor.) • Never use unspecified tester or other measuring device.
1.CHECK HARNESS CONNECTORCheck the connection of harness connector.
Is the connection normal? YES >> GO TO 2.
NO >> Replace harness connector.
2.CHECK WIRING HARNESSCheck the wiring harness externals.
Are the harness external parts normal (no damage)? YES >> GO TO 3.
NO >> Replace wiring harness.
3.CHECK AIR BAG CUTOFF SWITCH 1. Replace air bag cutoff switch..2. Perform DTC confirmation procedure. Refer to SRC-34, "DTC Logic".
Is DTC detected? YES >> GO TO 4.
NO >> INSPECTION END
4.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 1. Replace air bag diagnosis sensor unit. Refer to SR-30, "Removal and Installation".2. Perform DTC confirmation procedure. Refer to SRC-34, "DTC Logic".
Is DTC detected?
YES >> GO TO 1.
NO >> INSPECTION END