B1150 curtain air bag module LH
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On Board Diagnosis Function".
NOTE:SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected? YES >> Refer to SRC-120, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
WARNING:• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1.CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace harness connector.
2.CHECK WIRING HARNESSCheck the wiring harness externals.
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace wiring harness.
3.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 1. Replace air bag diagnosis sensor unit. Refer to SR-30, "Removal and Installation".2. Perform DTC confirmation procedure. Refer to SRC-120, "DTC Logic".
Is DTC detected? YES >> GO TO 4.
NO >> INSPECTION END
4.REPLACE CURTAIN AIR BAG MODULE 1. Replace curtain air bag module LH. Refer to SR-24, "Removal and Installation".2. Perform DTC confirmation procedure. Refer to SRC-120, "DTC Logic".
Is DTC detected
YES >> GO TO 1.
NO >> INSPECTION END