B1067, B1072 passenger air bag module
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On Board Diagnosis Function".
NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected? YES >> Refer to SRC-58, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK HARNESS CONNECTORCheck the harness connector.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace harness connector.
2.CHECK WIRING HARNESSCheck the wiring harness externals.
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace wiring harness.
3.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 1. Replace air bag diagnosis sensor unit. Refer to SR-30, "Removal and Installation".2. Perform DTC confirmation procedure. Refer to SRC-58, "DTC Logic".
Is DTC detected? YES >> GO TO 4.
NO >> INSPECTION END
4.REPLACE PASSENGER AIR BAG MODULE 1. Replace passenger air bag module. Refer to SR-19, "Removal and Installation".2. Perform DTC confirmation procedure. Refer to SRC-58, "DTC Logic".
Is DTC detected?
YES >> GO TO 1.
NO >> INSPECTION END