B210B starter control relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch under the following conditions to start engine, and wait 5 seconds or more.- Selector lever: In the P position - Brake pedal: Depressed 2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-213, "Diagnosis Procedure".
NO >> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 2 1. Stop engine. 2. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Refer to EC-366, "DTC Logic" (MR16DDT) or EC-725, "DTC Logic" (HR16DE). 3. Turn ignition switch ON.4. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Refer to SEC-213, "Diagnosis Procedure".
NO >> INSPECTION EN
Diagnosis Procedure
1.INSPECTION STARTPerform inspection in accordance with procedure that confirms DTC.
Which procedure confirms DTC? DTC confirmation procedure 1>>GO TO 2.DTC confirmation procedure 2>>GO TO 5.
2.CHECK DTC OF BCMCheck DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Perform the trouble diagnosis related to the detected DTC. Refer to BCS-67, "DTC Index".
NO >> GO TO 3.
3.CHECK IGNITION SWITCH START SIGNAL 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R harness connector.3. Check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace harness. Refer to STR-12, "CVT : Wiring Diagram".
4.PERFORM DTC CONFIRMATION PROCEDURE AGAIN 1. Reconnect IPDM E/R harness connector. 2. Turn ignition switch ON. 3. Select “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III. 4. Touch “ERASE”.5. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to SEC-213, "DTC Logic".
Is DTC detected? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> INSPECTION END
5.PERFORM DTC CONFIRMATION PROCEDURE AGAIN 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to SEC-213, "DTC Logic".
Is DTC detected? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> INSPECTION END