Security Control System without intelligent key system
P1616 ECM
In this manual: Security Control System without intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 1. Turn ignition switch ON amd wait 2 seconds or more.2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-199, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC CONFIRMATION PROCEDURE for DTC P1616. Refer to SEC-199, "DTC Logic".
Is DTC P1616 displayed again? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE ECMReplace ECM.
>> INSPECTION END
Was this page helpful?