Hood switch
Component Function Check
1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III.2. Check “HOOD SW” indication under the following condition.

Is the indication normal? YES >> Hood switch is OK.
NO >> Go to SEC-223, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK HOOD SWITCH SIGNAL CIRCUIT 1 1. Turn ignition switch OFF. 2. Disconnect hood switch connector.3. Check voltage between hood switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK HOOD SWITCH SIGNAL CIRCUIT 2 1. Disconnect IPDM E/R connector.2. Check continuity between IPDM E/R harness connector and hood switch harness connector.

3. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK HOOD SWITCH GROUND CIRCUITCheck continuity between hood switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace harness.
4.CHECK HOOD SWITCHRefer to SEC-224, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace hood switch.
5.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK HOOD SWITCH 1. Turn ignition switch OFF. 2. Disconnect hood switch connector.3. Check continuity between hood switch terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace hood switch.