B261A push-button ignition switch
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC B261A is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".
• If DTC B261A is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE1. Press the push-button ignition switch under the following conditions, and wait for 1 second or more.
CVT models
- Selector lever is in the P or N position - Do not depress brake pedal
M/T models
- Do not depress clutch pedal
2. Check “Self-diagnosis result” of BCM with CONSULT-III.
Is DTC detected? YES >> Go to PCS-101, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK IGNITION SWITCH OUTPUT SIGNAL (PUSH-BUTTON IGNITION SWITCH) 1. Disconnect push-button ignition switch connector and IPDM E/R connector.2. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT (BCM) 1. Disconnect BCM connector.2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

3. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK IGNITION SWITCH OUTPUT SIGNAL (IPDM E/R)Check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> Replace IPDM E/R.
NO >> GO TO 4.
4.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT (IPDM E/R) 1. Disconnect BCM connector.2. Check continuity between IPDM E/R harness connector and push-button ignition switch harness connector.

3. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace harness.
5.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END