Power Control System Power distribution system
B26F6 BCM
In this manual: Power Control System Power distribution system
~1min read
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC B26F6 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".
• If DTC B26F6 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE1. Turn ignition switch ON under the following conditions, and wait for 1 second or more.
CVT models
- Selector lever is in the P or N position - Do not depress brake pedal
M/T models
- Do not depress clutch pedal
2. Check “Self-diagnosis result” of BCM with CONSULT-III.
Is DTC detected? YES >> Go to PCS-107, "Diagnosis Procedure".
NO >> INSPECTION EN
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self-diagnosis result” of BCM with CONSULT-III. 3. Touch “ERASE”.4. Perform DTC Confirmation Procedure.
See PCS-107, "DTC Logic".
Is DTC detected? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation" NO >> INSPECTION END
Was this page helpful?