Push-button ignition switch position indicator
Description
Push-button ignition switch changes the power supply position.
BCM maintains the power supply position status.
BCM changes the power supply position with the operation of the push-button ignition switch.
Component Function Check
1.CHECK FUNCTIONCheck push-button ignition switch (“PUSH SWITCH INDICATOR”) in Active Test Mode with CONSULT-III.

Is the inspection result normal? YES >> INSPECTION END
NO >> Refer to PCS-111, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect push-button ignition switch connector.3. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection normal? YES >> GO TO 2.
NO-1 >> Check 10 A fuse [No.13, located in fuse block (J/B)].NO-2 >> Check harness for open or short between push-button ignition switch and fuse.
2.CHECK BCM INPUT 1. Connect push-button ignition switch connector. 2. Disconnect BCM connector.3. Check voltage between BCM connector and ground.

Is the inspection normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> GO TO 3.
3.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 1. Disconnect push-button ignition switch connector.2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

3. Check continuity between BCM harness connector and ground.

Is the inspection normal? YES >> Replace push-button ignition switch.
NO >> Repair or replace harness.