B26F1 ignition relay
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more.
CVT models
- Selector lever is in the P or N position - Do not depress brake pedal
M/T models
- Do not depress clutch pedal
2. Check “Self-diagnosis result” with CONSULT-III.
Is DTC detected? YES >> Go to PCS-103, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK IPDM E/R SELF-DIAGNOSTIC RESULT 1. Turn ignition switch ON. 2. Erase the DTC of IPDM E/R. 3. Turn ignition switch OFF.4. Turn ignition switch ON and check the DTC again.
Is DTC detected? YES >> Repair or replace the malfunctioning part. Refer to PCS-25, "DTC Index".
NO >> GO TO 2.
2.CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNALCheck voltage between BCM harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> Replace BCM. Refer to BCS-93, "Removal and Installation".
3.CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BCM and IPDM connectors.3. Check continuity between BCM harness connector and IPDM E/R harness connector.

Is the inspection result normal? YES >> Replace IPDM E/R.
NO >> Repair or replace harness.