Indicator lights
All-Wheel Drive (AWD) indicator
light (AWD model)
When the ignition switch is in the “ON” position, the All-Wheel Drive (AWD) indicator light illuminates and then turns off.
When selecting AWD mode while the engine is running, the AWD indicator light illuminates.
(See “All-Wheel Drive (AWD)” .)
All-Wheel Drive (AWD-V) indicator light (AWD model)
When selecting AWD-V mode while the engine is running, the AWD-V indicator light illuminates.
(See “All-Wheel Drive (AWD)” .)
Continuously Variable Transmission (CVT) indicator light (if so equipped)
When the ignition switch is in the “ON” position, the Continuously Variable Transmission (CVT) indicator light illuminates and then turns off.
Cruise indicator light
Cruise main switch indicator:
This light illuminates when the cruise control main switch is pushed. The light turns off when the main switch is pushed again. When the cruise indicator light illuminates, the cruise control system is operational.
Cruise malfunction:If the cruise indicator light blinks while the engine is running, it may indicate the cruise control system is not functioning properly. Have the system checked by a NISSAN dealer.
See “Cruise control” .
Engine start operation indicator
light (if so equipped)
This light appears when the shift lever is in the P (Park) position (Continuously Variable Transmission (CVT) models) or N (Neutral) position (Manual Transmission (MT) models). This light means that the engine will start by pushing the ignition switch with the brake pedal depressed.
You can start the engine directly in any position.
Exterior light indicator
This indicator illuminates when the headlight switch is turned to the AUTO (if so equipped),
or
position and the front parking lights,
instrument panel lights, rear combination lights, license plate lights or headlights are on. The indicator turns off when these lights are turned off.
Front passenger air bag status
light
The front passenger air bag status light (located on the center of the instrument panel) will be lit and the passenger front air bag will be OFF depending on how the front passenger seat is being used.
For front passenger air bag status light operation, see “NISSAN Advanced Air Bag System (front seats)” of this manual.
High beam indicator light
This light illuminates when the headlight high beam is on and goes out when the low beam is selected.
Malfunction Indicator Light (MIL)
If the malfunction indicator light illuminates steady or blinks while the engine is running, it may indicate a potential emission control and/or Continuously Variable Transmission (CVT) malfunction.
The malfunction indicator light may also illuminate steady if the fuel-filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 US gallons (11.4 liters) of fuel in the fuel tank.
After a few driving trips, the
light should turn off if no other potential emission control system malfunction exists.
The malfunction indicator light will illuminate in one of two ways:
• Malfunction indicator light illuminated steady — An emission control system and/or CVT malfunction has been detected. Check the fuel-filler cap if the LOOSE FUEL CAP warning message is displayed on the twin trip odometer. If the fuel-filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. Thedriving trips. If the
turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer.
• Malfunction indicator light blinking — An engine misfire has been detected which may damage the emission control system.
To reduce or avoid emission control system damage:
1) Do not drive at speeds above 72 km/h. 2) Avoid hard acceleration or deceleration. 3) Avoid steep uphill grades.4) If possible, reduce the amount of cargo being hauled or towed.
The malfunction indicator light may stop blinking and remain on.
Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer.
CAUTION Continued vehicle operation without having the emission control system and/or CVT system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system.
Security indicator light
The light blinks when the ignition switch is in the ACC, OFF or LOCK position. This function indicates the security system equipped on the vehicle is operational.
If the security system is malfunctioning, this light will remain on while the ignition switch is in the ON position. For additional information, see “Security systems” .
Turn signal/hazard indicator lights
The light flashes when the turn signal switch lever or hazard switch is turned on.
Vehicle Dynamic Control (VDC) off indicator light
The light comes on when the Vehicle
Dynamic
Control (VDC) off switch is pushed to OFF. This indicates that the VDC system and traction control system are not operating.