Transaxle & transmission 6MT: RS6F94R
Position switch
In this manual: Transaxle & transmission 6MT: RS6F94R
~1min read
Removal and Installation
REMOVAL
1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation". 2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation". 3. Disconnect position switch connector.4. Remove position switch from transaxle case.
INSTALLATION
1. Apply recommended sealant to threads of position switch.
• Use Genuine Liquid Gasket, Three Bond 1215 or an equivalent.
CAUTION:Remove old sealant and oil adhering to threads. 2. Install position switch to transaxle case. 3. Tighten position switch to the specified torque. Refer to TM-88, "Exploded View".
4. For the next step and after, install in the reverse order of removal.
Inspection
INSPECTION AFTER INSTALLATION
• Check continuity between position switch terminals. Refer to TM-73, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM-73, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).• Check the oil leakage. Refer to TM-75, "Inspection".
Was this page helpful?