Transaxle & transmission 6MT: RS6F94R
Side oil seal
In this manual: Transaxle & transmission 6MT: RS6F94R
~1min read
Removal and Installation
REMOVAL
1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE). 2. Remove front drive shafts. (K9K) Refer to FAX-78, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-79, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE).3. Remove differential side oil seals (1) from clutch housing and transaxle case, using an oil seal remover.
CAUTION:Never damage transaxle case and clutch housing.

INSTALLATION
Note the following, and install in the reverse order of removal.
• Install differential side oil seals (1) to clutch housing and transaxle case, using the drift [Stamping number: B.vi 1666-B] of the drift set [SST: KV32500QAA].
A : Transaxle case side B : Clutch housing side
Dimension “L1” : 1.2 – 1.8 mm (0.047 – 0.071 in) Dimension “L2” : 2.7 – 3.3 mm (0.106 – 0.130 in)
CAUTION:• Never incline differential side oil seal.
• Never damage clutch housing and transaxle case.

Inspection
INSPECTION AFTER INSTALLATION
Check the oil level and oil leakage. Refer to TM-75, "Inspection".
Was this page helpful?